The auto parts we can supply replacement parts for the Japaness and European vehicles,
especially for the Renault vehicles.
Auto Parts
A. Body parts : Fender, Hood, Door skin, Radiator support, Engine cradle,
Bumper, Grille, Moulding, Muffler.
A-1. Body parts tool : we also accept any body parts tool developing.
B. Engine parts : Water pump, Oil pump, Piston, Radiator, Cylinder liner,
Cam shaft, Cooling fan, Inlet valve, Outlet valve, Gasket, Suspension arm
C. Rubber parts : Hose, Elastic support, boots
D. Mechanical parts : Brake pad, Brake cylinder, Master cylinder, Tied
rod, Change lever assy, Wiper link assy
E. Lamp : Headlight, Taillight, Indicator light, Fog light.
E-1. Lamp tool : We also accept any lamp tool developingMotocycle
Parts
A. We can supply the parts that you request.
B. The detail items as follow :
1. Frame :
Frame, Front Fork, Head Parts, DLR Comp Center Inn, Rear Fork, Handlebar, Saddle, Fender,
Cushion, Pedal, Alloy Kick Starter, Luggage Carrier, Kickstand, Tank Cap, Exhaust Pipe
& Muffler
2. Engine Parts :
Cylinder Linerm Piston, Piston Ring, Piston Pin, Piston Clip, Carburetor, Winker Assy Fuel
Cock,
Oil Pump, Filter, Filter Element, Oil Filter, Plug Drain, Cylinder Head, Cylinder Block,
Crank Shaft
3. Transmission Parts :
Clutch Facing, Clutch Friction Plate, Clutch Hub, Gear, Plastic Gear, Shafts, Ball
Bearing, Chain,
Chain Case
4. Wheel Parts :
Wheel, Rim, Wheel Cap, Tube and Tire, Tire Valve, Valve Inside Core
5. Electrical Parts :
Battery, Contact Point Set, Ignition, Coil, Distributor, C.D.I. System, AC Generator,
Starter,
Regulator, Relay, Condenser, Switch, Eletric Parts, Flasher, Buzzer, Micro Motor
6. Brake Parts :
Brake Master, Brake Lining, Brake Shoes, Brake Pedal, Wheel Hub Drum
7. Electrical Lighting & Signaling :
Lamp, Tail Lamp, Bulb, Flasher, Horn, Switch, Fuse
8. Miscellaneous :
Engine Gasket, Inner Wire, Steel Ball, Cone Steering, Tool Kit, Back Mirror, Meter, Lock,
Air
Pump, Plastic Parts, Rubber Parts, Stamping Parts, Casting Parts, Tool & Dies, Forging
 |
 |
Machining Parts
We can supply any parts for O.E.M. especially mechanical parts that machined by
follow process (according the Drawing definition that including : material, profile,
presision & function):
A. Turning machining with CNC lathe & turning center.
B. Milling & Drilling machining with machining center.
C. Granding machining
D. Die-casting : Cast-iron casting, aluminum casting. we also accept the
above casting tool request.
Contact Information
No.274, Mei Te Street, N. Dist, Taichung, Taiwan.
Tel : 886-4-5820112 Fax : 886-4-5822839
E-mail: samputi@ms26.hinet.net
|
